Pot Light Installation York
Pot Light Installation York
York · Pot Lights & Lighting
Recessed lighting across York — low ceilings, plaster, and the original wiring behind it, handled by a shop that is ten minutes away.
Our shop is on McRoberts Avenue, in York. The housing here went up between roughly 1913 and 1940 and most of it still has the ceilings it was built with — plaster, often lower than people expect, with very little room above.
Low ceilings and tight joist bays are the norm here. Slim wafer fixtures exist for exactly this, and we size to what the cavity actually allows.
Scored and cut properly so the keys behind the lath stay put, with the patching agreed in writing before we start.
Nearly half of York's homes predate 1961. Where the existing lighting circuit is original, a new run from the panel is usually the right call.
From McRoberts we reach most of York in ten to fifteen minutes, so we can look at the ceiling before quoting it.
York was built as a streetcar suburb and the construction is consistent — which helps, once you know what to expect.
Close to half of York's housing was built before 1961, which means plaster ceilings and original lighting circuits sized for one bulb per room. Adding six fixtures to a circuit like that is not a tap-in job.
Many York semis and bungalows have ceilings under eight feet with shallow joist bays, sometimes crowded with later ductwork. Fixture depth matters here in a way it does not in newer housing.
York records 8.9% of dwellings needing major repairs, the highest of our areas. When we open a ceiling here we sometimes find the wiring above it needs attention before anything new goes in — we tell you straight away rather than working around it.
We are minutes away, so the site visit happens before the quote. On York ceilings that is the difference between a price and a guess.
We establish what feeds the room and whether it can take the load, before choosing fixtures.
Fixtures aligned, dimmer matched to the driver, ESA notification filed under our licence.
We work right across York. If your street is not listed it almost certainly still counts — see pot light installation in full, or our York electricians page.
Yes — our shop is on McRoberts Avenue. Most of York is a ten to fifteen minute drive, which is why we look at ceilings in person before quoting rather than pricing off a photo.
Usually yes. Slim wafer LEDs need very little depth and exist for exactly this situation — they clip into the hole with a small driver box pushed into the cavity. What matters is checking the joist bay for ductwork and plumbing first, which in York's older housing is often crowded.
The fixtures are new regardless; the question is the circuit feeding them. In a pre-1961 York home the existing lighting circuit is often original and sometimes knob-and-tube, which cannot legally be extended. A new circuit from the panel is frequently the honest answer, and we will say so.
More than drywall, less than people fear. The fixture openings themselves are clean; the making good is around wiring runs that cross joists. We agree who patches and to what standard in writing before starting, which is what Ontario's consumer protection rules require of a written contract anyway.
That is the best time. With the ceiling open the wiring runs are straightforward and there is no patching at all. If a renovation is coming, get the lighting layout designed then rather than retrofitting afterwards.
What drives the price, and why the same room gets quoted so differently.
Read more →IC rating, CRI, dedicated circuit and the rest, in plain English.
Read more →Adding lighting is an alteration. Here is what that actually involves.
Read more →Nearby: TorontoEtobicokeEast York. Related services: Pot Light Installation · Renovation Electrician · Residential Electrical. Or see every area on our service areas page.
We are on McRoberts Avenue. We will come and look at the ceiling.